The AT-OC9XEB dual moving coil stereo cartridge features a bonded elliptical stylus, aluminum cantilever, neodymium magnet and pure iron yoke providing higher magnetic energy.
It is characterized by its glued elliptical needle and aluminum cantilever
A neodymium magnet and pure iron yoke provide higher magnetic energy. Threaded inserts in the cartridge body allow the cartridge to be mounted to the headstock or integrated arm with just two screws, no nuts needed. Aluminum minimizes unwanted vibration for reduced resonance and superior audio reproduction Pure continuous cast oxygen-free copper (PCOCC) is used for coils to achieve the purest signal possible
Features:
- Frequency Response: 20 - 30,000 Hz
- Channel Separation: 25 dB (1 kHz)
- Vertical Tracking Angle: 20 degrees
- Vertical Tracking Force: 1.8 to 2.2 g (standard 2.0 g)
- Needle Construction: Glued round shank
- Recommended Load Impedance: Minimum 100 Ohms
- Coil Impedance: 12 Ohms (1 kHz)
- DC Resistance: 12 Ohms
- Coil Inductance: 25 µH (1 kHz)
- Output Voltage: 0.32 mV (at 1 kHz, 5 cm/sec)
- Output Channel Balance: 1.5 dB (1 kHz)
- Needle Shape: Glued elliptical
- Cantilever: Aluminum tube
- Static Compliance: 20 x 10 – 6 cm / dyne
- Dynamic Compliance: 9 x 10 – 6 cm / dyne (100 Hz)
- Mounting: 1/2” center / Threaded holes
- Dimensions: 17.3 (H) x 16.8 (W) x 25.7 (L) mm
- Accessories Included: 1 non-magnetic screwdriver; 1 brush; 2 washers; 4 pairs of mounting screws 5mm, 8mm, 10mm, 12mm; 1 plastic protector
- Body Material: Aluminum
- Needle Size: 0.3 x 0.7 mil
- Terminal Pins: Copper
- Weight: 7.6g
- Wire Used for Coil: PCOCC (Ohno Continuous Casting Process Copper.)
