Years of experience in manufacturing high quality headphone amplifiers have been distilled into the design of the MX-HPA. As a result, this fully balanced headphone amplifier delivers an impressive listening experience. The technical performance of the MX-HPA is superlative.
Typically, the distortion from 20Hz to 40kHz is less than 0.005%. The signal-to-noise ratio is better than 120dB ('A'-weighted). Frequency response is a flat ruler from 10Hz to 20kHz (-0.1dB). The MX-HPA is capable of a short-term peak of 10 watts (for one cycle) and has two gain settings: 18dB (8X) and 24dB (15X). The MX-HPA will automatically convert RCA line inputs to balanced. The design of the MX-HPA is completely balanced from start to finish.
Characteristics:
- High-end headphone amplifier.
- Circuitry with fully balanced design.
- Frequency response: 10 - 40,000 Hz at +0, -3dB.
- Ultra low distortion level less than 0.003%, 20 - 20,000 Hz.
- Output impedance up to 32 Ohm.
- Input impedance 50,000 Ohm.
- Output power: 2 x 1.8W @ 8 Ohm.
- Maximum voltage output: 19V RMS (20 - 20,000 Hz).
- Audio inputs: 1 x MiniXLR (5-pin connector) and 1 x stereo RCA.
- Audio Outputs: 1 x Balanced XLR and 1 x Stereo RCA.
- Gain selector.
- Front jacks for two balanced XLR type headphones and 6.3mm stereo jack.
- Measurements: 220 x 53 x 240mm.
- Weight: 2.2kg.
8 other products in the same category: